Plasterboard plug, zinc die-cast without screw
- Nominal diameter: 14.5 mm
- Nominal length: 33 mm
- Min. screw diameter: 4.0 mm
- Max. screw diameter: 5.0 mm
- Material: Die-cast zinc
- Screw length condition: 30 mm + Height attachment part
- Minimum component thickness: 9.5 mm
Exclusively for trade customers
- Price display and ordering for customers after registration
- Register now and access more than 50,000 products
Non-load-bearing masonry, plaster or insulation must be taken into account. These are not considered anchoring substrates.
This information is based on factory testing. It should be considered a general recommendation and must be adapted to the respective materials by local testing. A safety factor must be taken into account. The information does not apply to cases requiring technical approval. It does not constitute approval. Recommended safety factor: 5x
Special anchor for fastening e.g. gas and electrical installations, lighting, pictures, light shelves etc. in gypsum plasterboard, lightweight panels and aerated concrete in combination with a wood or chipboard screw.
Cotter-pin mounting
Screw in the plasterboard plug flush without pre-drilling with low torque (PZ 2-bit) directly into the plasterboard
Fix with screw
Screw length = 30 mm + component thickness
- Nominal diameter: 14.5 mm
- Nominal length: 33 mm
- Min. screw diameter: 4.0 mm
- Max. screw diameter: 5.0 mm
- Material: Die-cast zinc
- Screw length condition: 30 mm + Height attachment part
- Minimum component thickness: 9.5 mm
