HOX drive
– perfect fit of the bit results in a long service life of the bit
– perfect power transmission, thus no damage to the head and surface (no corrosion)
– no discharge effect due to greatly improved working comfort (no wobbling)
– hold effect due to conical geometry (stick effect), which increases productivity by saving processing time
– commercially available TX bit usable (the mentioned advantages of the HOX bit do not apply)

HOX head stamping
– user safety through visible approval when installed

countersunk head with milling pockets
– flush-mount countersinking of the screw head leads to a perfect processing appearance
– low chipping at the surface, which prevents damage to the head and the component surface (no corrosion)
– minimum damage to coated materials
– lower energy and force expenditure due to light and clean countersinking of the screw head
– suitable for wood and fittings

under-head reinforcement
– user safety due to maximum resistance against tearing

end mill (friction part) (from 80/ 90 mm screw length)
– less friction on the screw shaft ensures tool-friendly processing
– less energy and force as it acts like a drill
– reduction of the screw-in resistance
– easy processing of long screws

coarse thread and single-start thread
– always provides the optimum processing speed for each screw length
– up to 40% faster processing
– up to 30% higher pull-out values

30° peak with reset second thread
– low splitting forces due to drilling effect
– reduced tendency to split in the edge area enables edge area screw connections
– extremely fast "biting" of the screw

high-quality hardened steel
– high breaking torque
– highest processing quality

anti-friction coating
– light and clean screw-in
– lower energy and force

ETA-12/0373

free bit in each screw pack
– suitable bit always available directly with material

The HOX professional screw is the optimal fastening medium for construction, furniture, skirting boards, formwork, fittings and panelling.
In damp rooms and outdoors, non-corrosive materials must be used for mounting (DIN 18360, Section 3.1.4.1).
The user is responsible for design considerations.

Installation must be carried out in accordance with the approval certificate!

HOX partial thread, single-start thread

Stay up to date