Ceiling nail, zinc plated
- Material: Steel
- Surface: Zinc plated
- Nominal diameter: 6 mm
- Minimum component thickness: 80 mm
- Min. drill hole depth: 40 mm
- Drill hole diameter: 6 mm
- Min. centre-to-centre distance (s min): 200 mm
- Min. centre-to-centre distance/for edge clearance c R30-R120 (under fire stress) s min/c: 150 mm
- Anchoring depth (h nom): 32 mm
- Width Package: 90.00
- Height Package: 80.00
Exclusively for trade customers
- Price display and ordering for customers after registration
- Register now and access more than 50,000 products
- High load-bearing capacity in cracked and uncracked concrete
- Small drilling diameter and low effective anchorage depth
- Fire resistance class R120
The use of a ceiling nail is limited to the multiple mounting of non-load-bearing systems in concrete: Anchorage with European Technical Approval in cracked concrete (tension zone) and non-cracked concrete (compression zone).
For this reason, the following applies to mountings with ceiling nail:
- The anchor has European Technical Approval for use in reinforced or unreinforced standard concrete with a strength class of min. C20/25 and max. C50/60 in accordance with EN 206-1:2000-12
- The ceiling nail can only be used in dry indoor room conditions
- Suitable for anchorages with predominantly static loads (e.g. tare weight, fittings, stored materials) or quasi-static loads (e. g. façade constructions, railings)
- Suitable for attaching lightweight ceiling cladding and suspended ceilings, metal profiles, perforated strips, vernier hangers, wooden strips, wooden laths, square timbers, etc.
In-place installation
Create a drill hole perpendicular to the concrete surface
Clean out the drill hole by blowing it out or vacuuming it
Alternatively, when the drill hole depth is reached, pull out the drill bit while the drill is switched on. In order to reduce the amount of drill cuttings in the drill hole, repeat this step at least three times, starting at the bottom of the drill hole (ventilate the drill hole)
Insert the ceiling nail until it touches the fixture
Drive in the protruding pin
Installation must be carried out in accordance with the ETA!
- Material: Steel
- Surface: Zinc plated
- Nominal diameter: 6 mm
- Minimum component thickness: 80 mm
- Min. drill hole depth: 40 mm
- Drill hole diameter: 6 mm
- Min. centre-to-centre distance (s min): 200 mm
- Min. centre-to-centre distance/for edge clearance c R30-R120 (under fire stress) s min/c: 150 mm
- Anchoring depth (h nom): 32 mm
- Width Package: 90.00
- Height Package: 80.00
