Insulation holder, metal
- Material: Steel
- Surface: Zinc plated
- Diameter: 8 mm
- Length: 110 mm
- Head diameter: 35 mm
- Embedding depth: 40 mm
- Anchoring depth (h v): 40 mm
- Min. edge clearance: 60.0 mm
- Min. drill hole depth: 45 mm
- Max. height of the fixture: 70 mm
- Min. centre-to-centre distance (s min): 120.0 mm
Exclusively for trade customers
- Price display and ordering for customers after registration
- Register now and access more than 50,000 products
Conforms to building material class A1.
For determining the permissible load, the partial safety coefficient from the approval certificate of ƴM = 1.5 was taken into account on the resistance side and a partial safety coefficient of ƴF = 1.4 on the impact side.
The metal insulation holder is only suitable for multiple fixings of insulation plates: Anchorage with general technical approval in cracked concrete (tension zone) and non-cracked concrete (compression zone).
The following applies to attachments with metal insulation holder:
At least four metal insulation holders must be used for each insulation material plate to be fastened
The metal insulation holder has general technical approval for use in reinforced or unreinforced standard concrete with a strength class of min. C20/25 and max. C50/60 in accordance with DIN EN 206-1:2001-07 "Concrete – Part 1: Definition, properties, production and conformity"
The use of the metal insulation holder is only permitted under dry interior conditions
Suitable for the mounting of soft and pressure-resistant insulation materials such as rock wool, polystyrene, sandwich panels or cork in the materials concrete, solid masonry, light concrete and perforated brick masonry
Push-through installation
Create a hole through the insulation plate
Clean the drill hole
Knock the insulation holder through the insulation plate with a hammer
The retaining plate must rest completely on the insulation plate
At least 4 insulation holders must be used per m² of plate. The axis and edge distances apply without fire requirements.
If possible use under fire load is expected, the arrangement of the insulation holders from the general construction inspection certificate must be observed!
- Material: Steel
- Surface: Zinc plated
- Diameter: 8 mm
- Length: 110 mm
- Head diameter: 35 mm
- Embedding depth: 40 mm
- Anchoring depth (h v): 40 mm
- Min. edge clearance: 60.0 mm
- Min. drill hole depth: 45 mm
- Max. height of the fixture: 70 mm
- Min. centre-to-centre distance (s min): 120.0 mm
